Condes course planning - discussion forum
Renumbering
May 20, 2018 05:24PM
I'm wanting to renumber my controls, but have specifc ranges of numbers available, and there doesn't seem to be a way to specify this?
Finn Arildsen
Re: Renumbering
May 26, 2018 11:03PM
Hi,

The renumbering feature respects the configured “first control code”. It also respects a predefined set of control codes, which you can configure using File / Settings for this PC. This is really meant as a set of punch pattern for the “backup” pin punches, but I think it is possible to omit the actual patterns an only enter the codes.

Regards
Finn
Author:

Your Email:


Subject:


Attachments:
  • Valid attachments: wcd,ocd,jpg,tif,png,jgw,tfw,pgw
  • No file can be larger than 62.5 MB
  • All files together cannot be larger than 62.5 MB
  • 5 more file(s) can be attached to this message

Spam prevention:
Please, enter the code that you see below in the input field. This is for blocking bots that try to post this form automatically.
  *******   **     **   *******   ********  ******** 
 **     **   **   **   **     **     **     **       
 **     **    ** **    **     **     **     **       
  ********     ***      ********     **     ******   
        **    ** **           **     **     **       
 **     **   **   **   **     **     **     **       
  *******   **     **   *******      **     ******** 
Message:
This is a moderated forum. Your message will remain hidden until it has been approved by a moderator or administrator