Condes course planning - discussion forum
Welcome! Log In Create A New Profile

Advanced

star exercise training

Posted by Denise Wright 
star exercise training
January 07, 2004 05:58PM
Dear Finn,

Could I ask your advice on the best way to use Condes to print out just a start and one control on the map, for using in a star training exercise.

I've tried creating each control as a seperate course, which looks OK, with the start triangle, line to control and control circle. The only problem is that every map has the number '1' next to the control because it is the 1st control on the course. Would it be possible to have either no number printed or the real control number?

Or is there any other way of doing this?

Denise.
Re: star exercise training
January 07, 2004 06:28PM
Finn,

Many thanks for the prompt reply. Changing it to 'code only' was all that was needed.

Thanks for providing this great piece of software.

Denise.
Author:

Your Email:


Subject:


Attachments:
  • No file can be larger than 62.5 MB
  • 5 more file(s) can be attached to this message

Spam prevention:
Please, enter the code that you see below in the input field. This is for blocking bots that try to post this form automatically.
  ******   **     **        **  ********  ********  
 **    **  **     **        **  **        **     ** 
 **        **     **        **  **        **     ** 
 **        **     **        **  ******    ********  
 **         **   **   **    **  **        **        
 **    **    ** **    **    **  **        **        
  ******      ***      ******   **        **        
Message:
This is a moderated forum. Your message will remain hidden until it has been approved by a moderator or administrator