Condes course setting
Welcome! Log In Create A New Profile



Posted by Ali Wood 
This forum is currently read only. You can not log in or make any changes. This is a temporary situation.
May 20, 2018 05:24PM
I'm wanting to renumber my controls, but have specifc ranges of numbers available, and there doesn't seem to be a way to specify this?
Finn Arildsen
Re: Renumbering
May 26, 2018 11:03PM

The renumbering feature respects the configured “first control code”. It also respects a predefined set of control codes, which you can configure using File / Settings for this PC. This is really meant as a set of punch pattern for the “backup” pin punches, but I think it is possible to omit the actual patterns an only enter the codes.