Line Dimensions
Previous Topic  Next Topic 

This dialog is used to set up the dimensions of course leg lines on the currently active canvas

Note: The settings in this dialog apply for all courses on the active canvas shown at the top header of the dialog.  If you would like to configure one of the other canvases, first select the relevant canvas from the drop-down list.

Radius dimensions are measured in millimeters at 0.01 mm precision.


Use dimensions from canvas X

This setting appears only when you have chosen in the Setup Controls dialog to use control coordinates from another canvas.

Check this option if you want to use the same line widths and circle dimensions as on the original canvas.  If you modify a line width or circle dimension, this will be reflected on both canvases.

if the print scale of the map differs between the two canvases, then dimensions on this canvas are scaled proportionally (stretched/shrunk) with the print scale.  For example, if the original canvas uses print scale 1:15,000, and this canvas uses print scale 1:10,000, then dimensions used on this canvas are those configured on the original canvas, but increased by 15/10 = 3/2 = 50%.


Line Width

is the width of the lines used for course overprints.  The IOF standard is 0.35 mm.

Circle/line gap

controls the gap between the control circle and the connecting line.


GET from My Standard Settings

Click this button to set all the values in this dialog to the values that you have saved as your own standard settings.

SAVE to My Standard Settings

Click this button to save all the values in this dialog as your own standard settings.

Reset to Condes Standard

Click this button to reset all the values in this dialog to the Condes standard values.