This dialog is used to set up the dimensions of courses symbols on the currently active canvas. 

Note: The Setup Circle and Line Dimensions dialog configures settings for the canvas that is currently active.  If you want to configure one of the other canvases, first select the relevant canvas from the drop-down list.

Radius dimensions are measured in millimeters at 0.01 mm precision.

Control circle radius

controls the size of the control circles.   The IOF standard is 3 mm.   Condes keeps two different settings for the control circles' radius:

1. The "On a course" radius is used when a course is drawn. 
2. The "On the "all controls" map" radius is used when Cones draws a map with all controls, and in the "Controls" mode in the Course Layout Editor.  If you have many controls close together on the "all controls" map, it can be difficult to distinguish the circles, and in this case it may be a good idea to use a smaller radius for the circles on the "all controls" map.

Line Width

is the width of the lines used for course overprints.  The IOF standard is 0.35 mm.

Circle/line gap

controls the gap between the control circle and the connecting line.

Start radius

controls the size of the start triangle by defining the distance from the centre to one of the corners.

Finish radius (inner and outer)

controls the size of the finish circles.

GET from My Standard Settings

Click this button to set all the values in this dialog to the values that you have saved as your own standard settings.

SAVE to My Standard Settings

Click this button to save all the values in this dialog as your own standard settings.

Reset to Condes Standard

Click this button to reset all the values in this dialog to the Condes standard values.