Course Color
Previous Topic  Next Topic 

This dialog is used to set up the dimensions of course leg lines on the currently active canvas

Note: The settings in this dialog apply for all courses on the active canvas shown at the top header of the dialog.  If you would like to configure one of the other canvases, first select the relevant canvas from the drop-down list.

Radius dimensions are measured in millimeters at 0.01 mm precision.


Course overprint color

The color used for course overprinting.  This color is used for lines and text (numbers) when overprinting courses.

This color is used when printing on a printer or exporting as PDF, EPS, OCD, and bitmap files. 

When Condes shows the course on the screen in the Course Layout Editor, other colors are used, primarily Magenta, but also blue and red are used in certain editing modes.

String O line color

The color used for the line indicating the marked route from start to finish on a String course and a String course with controls.


Overprint

Use overprint for course overprint

Check this box to use overprint effect for the course overprint.

Overprint effect means that when printing, the overprint will not "knock out" the map under the circles and lines.  Instead you will be able to see details of the map underneath the line, which would otherwise be covered by the line. 

This emulates "real" overprinting, but is currently not a 100% correct emulation.  

Please note that PostScript printers do not support overprinting effect.  Condes can simulate this effect also on PostScript printers.  See  Setup Application.

Do NOT make overprint effect for control numbers

This box is available only when the "Make overprint effect" box is checked.  If you check this box, the control numbers (and control codes) will "knock out" the map underneath instead of using overprint effect.


Outline course

Condes can draw a white outline on the course overprint on the map. This is an option to make the overprint more readable on a busy background.  This section is separated into three components:

Make white outline on control circles

Check this box to draw a white outline on control circles.

Make white outline on control numbers

Check this box to draw a white outline on control numbers and control codes.

Make white outline on course legs

Check this box to draw a white outline on course leg lines.


GET from My Standard Settings

Click this button to set all the values in this dialog to the values that you have saved as your own standard settings.

SAVE to My Standard Settings

Click this button to save all the values in this dialog as your own standard settings.

Reset to Condes Standard

Click this button to reset all the values in this dialog to the Condes standard values.